Home > Products > Filtration >

Leaf Eater Advanced
leaf eater advanced 3" RHAD98


 
Alternative Views:


List Price: $37.95
Our Price: $33.00
You save $4.95!

Product Code: FILTLEA


Size*:


 
Description Technical Specs
 

Rain Harvesting Pty Leaf Eater Advanced (3")

Available in 3" and 4" sizes




Keeps your Rain Harvesting system free of mosquitoes, vermin and debris.

The Leaf Eater AdvancedTM is the next generation Rain Head, featuring the new patented CleanshieldTM (single screen) technology and VH PivotTM outlet. The Leaf Eater AdvancedTM Rain Head prevents debris from entering the Rain Harvesting system, improves water quality and reduces tank maintenance. The single screen incorporates CleanshieldTM technology which deflects leaves and debris away from the flow of water. This minimises maintenance and enhances catchment efficiency. This Rain Head incorporates a VH PivotTM outlet that swivels to suit vertical or horizontal downpipes.

The Leaf Eater AdvancedTM can also be used as a debris removing device even when rainwater is not being collected.



Installation Instructions

Gutter & Mid-Mount Installation

1. Gutter: Measure 208mm from the bottom of the existing gutter pop and remove this section of downpipe. Ensure the cut edge is clean and smooth. Mid-Mount: Remove 208mm of downpipe where the Leaf Eater Advanced™ is to be situated. Ensure all cut edges are clean and smooth. (figure 1)
2. Using the quick release tabs remove the Cleanshield™ screen by lifting it up and then out. (figure 2)
3. Insert the Leaf Eater Advanced™ by sliding it up over the cut section and then down into position. The Leaf Eater Advanced™ outlet should be slid firmly onto the bottom down pipe until it can be pushed no further. (figure 3)
4. Screw the Leaf Eater Advanced™ into position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used. (figure 5)
5. Insert the Cleanshield™ screen into the Leaf Eater Advanced™. Ensure the Cleanshield™ screen is sitting firmly in place and check installation is secure. (figure 6)



Horizontal (Rear Outlet) Installation

1. Using the quick release tabs remove the Cleanshield™ screen by lifting it up and then out. (Figure 2)
2. Swivel the outlet to the horizontal position – some force may be required.
3. Position the Leaf Eater Advanced™ next to existing pipework, mark and cut top and bottom cut lines as per figure 4 . Ensure the cut edge is clean and smooth.
4. Insert the Leaf Eater Advanced™ by sliding the rear outlet into the horizontal pipe. The back fixing plate must sit behind the top section of downpipe. (figure 3)
5. Screw the Leaf Eater Advanced™ into position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used. (figure 5)
6. Insert the Cleanshield™ screen into the Leaf Eater Advanced™. Ensure the Cleanshield™ screen is sitting firmly in place and check installation is secure. (figure 6)
Features
  • Compact, versatile rain head for quick and easy installation
  • Patented single screen technology for advanced debris shedding (Clean Shield™)
  • Minimal maintenance
  • Pivot the outlet to suit vertical or horizontal (rear outlet) downpipes – variety of installation options in one product (VH Pivot™ patent pending)
  • High flow rate performance
  • Superior catchment efficiency at low and high flow rates
  • Single screen with 0.955mm aperture mosquito proof stainless steel mesh
  • Available in 90mm or 100mm outlet

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:


Products > Filtration
Products > Filtration > Down Spout