Clean Rain Advanced™ is an all-in-one rain head, first flush diverter and stormwater overflow. Simple and reliable mechanics allows the rain head filter (patented Clean Shield™ technology) to shed leaves, while the ‘Smart Sense’ first flush diversion system automatically activates when water is detected and diverts the first flush of rainwater which contains contaminants from the roof to stormwater.
Clean Rain® allows the user to connect multiple outlet hoses to direct water to a pool, garden or storage tanks. The Clean Rain® body also rotates 180° allowing it to easily adapt to different installation environments.
1. Remove 600mm of downpipe from where the Clean Rain® is to be situated. Ensure all edges are clean and smooth.2. Using the quick release tabs remove the Clean Shield™ by lifting it up and out.3. Fit the correct downpipe adaptor to the bottom of the Clean Rain®.4. Install the Clean Rain® by sliding it up behind the top section of cut downpipe and then down into position. The Clean Rain® should be slid firmly onto the bottom downpipe until it can be pushed no further.5. Screw the top of the Clean Rain® in position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used.6. Insert the Clean Shield™ back into the Clean Rain®. Ensure the Clean Shield™ is sitting firmly in place and check installation is secure.